![Boot menu modbo 5.0](https://kumkoniak.com/14.jpg)
* Software selectable "PS2 Quick Load" option. * Automatic selection for PS2/PS1/DVD supports * Comes with mini size board and the wiring point order is good for installation * Upgraded from modbo3.0, comes with original 100% v1.88 firmware, but it isn't upgradeable * Fully compatible with ps2 v1-v16 PAL / USA / Jap
![boot menu modbo 5.0 boot menu modbo 5.0](https://4.bp.blogspot.com/-wHbRae19hlI/TgtTK8rCGQI/AAAAAAAAAwc/uiHMyq4et30/s1600/hdd1.jpg)
* USB HARD DRIVE and Memory Stick Support! You can also easily disable the usb boot option and use the modbo 5.0 in the same way as you have always used your modbo 4.0. The installer will load, and you will have an option to choose which partition you created earlier. Select the ‘Install PrimeOS option from the GRUB menu. I tend to prefer the position in the other example.MODBO 5.0 is an new generation of PS2 MOD chip that integrates a USB boot menu so you can play games from usb hard drive or usb memory stick! start the console without any CD/DVD.Įven better, the install is exactly the same as the Modbo 4.0, so if you want to upgrade, you can just replace the modchip without needing to solder all the connections to the ps2 motherboard again. Turn off the secure boot of your device and then boot up the PrimeOS USB by pressing Esc or F12, depending on your bios menu key, and selecting the PrimeOS USB to boot from. It shows that there are multiple valid places you can position the chip and have a working install. This is an example of an installation into the first diagram with the Modbo 4.0 chip. I found some alternative points for some of the connections (like Q, T, U, V, and R). This board matches the second diagram with the Modbo 750 chip. Leave a comment and I'll add your installation to the list This section has photos of some successful installations which you can use to get a better understanding of how everything is wired and positioned.
- Make sure wherever you are putting your chip won't cause any issues when putting the system back together, PS2 slims fit together very tightly.
- Use some thicker wire for the 5V and ground wires.
- Using 30 AWG solid core wire works well for most of the points.
- Here are some tips I have for you when you are soldering your chip into a V15. Some example versions are Modbo 3.0, Modbo 4.0, Modbo 5.0, and Modbo 750.įor more information about Modbo modchips click here, for more information about PS2 modchips in general click here. Note that there are multiple versions of the Modbo modchips available, but the installation diagrams are all the same. Note that there can be multiple board numbers within a specific model number.
You can find the model number on the sticker on the bottom of the console, and the board number is printed on the PS2 main board if you take apart your console.
Matching console model numbers and board numbers are listed below. They were found in SCPH-7700x models available worldwide. One of the revisions of the slim PlayStation 2 was the V15.